Review on 🔧 MulWark 20pc 1/4 Inch Super Low Profile Ultra-Compact Tool Set by Carlos Long

I purchased this ratchet specifically for fastening some panels in tight corners where existing panels on the adjacent wall made it impossible to fit a straight wrench (or even a 1/4 allen wrench). This screwdriver and included bits did the job pretty well. It's probably only strong enough for light work, but even then it can apply a lot more torque to the screw than a regular straight screwdriver, especially with a hex or torx screwdriver. bits. Most common Philips bits will most likely just pop out (this is a design artifact of the Philips screwdriver, not a tool fault) - you will actually have a hard time pushing the ratchet head when trying to tighten the Philips screw. If I were to change anything on the tool, I would lower the ratchet selector a bit. It's surprisingly easy to accidentally hit the selector when tightening the ratchet, leaving the knob useless.