Review on Rousseau 3509 9 Inch 12 Inch 8 Inch by Eric Alcantara

Funny how many complain about the raised center. Most milling bits I have measured and/or read have a recessed/concave center (although they are sold as "flat"). the center of the disk where the bit is. If the center is concave, which is what you should be doing, pretty much anything you do will have a curve in it as the piece goes in and out of the indentation. Stupid. I have two routers, both are constantly connected to these tablets. The old one was installed and has been hanging since 2001. Its dimensions are identical to the new one. I'm happy. However, it would be nice if a simple ring with a 1/2" hole was included to center the router. Once the router bit was in place, a small piece could be lifted through it, turning it into a slack ring.