Review on 🔧 DEA A7363 Front Right Engine Torque Strut Mount - Ultimate Stability for Superior Engine Performance by Matthew Flores

I saw a video where the replacement was complicated by removing the entire hood. It took him about 45-60 minutes and I only about 20 minutes. The only part I had to remove was the power steering reservoir, which is a metal clip that you pull out by lifting the reservoir. There are two 13mm screws on the metal plate above the rear screw which I had to remove so I could carefully pry the metal plate up to allow enough room to remove the vertical screw near the firewall. Since this could put pressure on the underside of the windshield, I was very careful with the angle and amount I pressed against the metal plate. Bushing hub center, which probably wasn't necessary, but I wanted it anyway. All in all a very easy job that anyone with an 18mm wrench should be able to do.