Review on 🖨️ Marble Filament Printing Printer by Eryone by Craig Shah

We have mixed feelings as we've made some great prints with this yarn but it took a few prints. Issues: 1) Adhesion to the build plate can be quite difficult. So difficult that we gave up and started using painters tape to make it happen as we couldn't get it to stick any other way (even with a raft). 2) He's a little more fragile than we're used to. too, causing it to click a few times in the extruder. Those few times there seemed to be no trouble anywhere else. 3) It seems to be prone to clogging inside the tube due to filament thickness variation outside of the error limit, which also leads to this extruder cold end failure. This has already happened several times - for example, this meant that our supplied image of the Eiffel Tower could not be printed after about 26 hours ("nooo"). it looks good. The marbling effect is a little average, but it does make a difference compared to your regular grayscale (don't get me wrong, it's noticeable, they're probably just there to prevent nozzle clogging). ). It's promising, it just shouldn't fail so easily and have so many problems sticking to the plate. Unfortunately, we burned so much filament on the failed prints that we had to remove some of the stars.** If you found our review helpful, please rate it below so we know. This helps us to provide quality feedback in the future.