🖨️ Marble Filament Printing Printer by Eryone Review

I just received my first printer. . . Ender 3 Pro. Passed 1/2 roll Black PLA from Eryone and I really liked it. . no problems except a few mistakes i made which were user error. I just switched filaments to start using this marble PLA and it doesn't seem to print the same at all. Using the same setting that gave me near perfect results with black thread leaves a few lumps and feels more viscous. . . Adhesion doesn't seem as good as black, but it's not really an issue. We'll see how this one…

Marcus Aurelius and Leo printed almost perfectly on a Prusa I3 MK3S nozzle at 220°C and 70°C bed with Prusa textured foil and 0.40mm E3D hardened steel nozzle. No problems, prints very well. Please note that I did not use smooth PEI film as adhesion will not be an issue with a properly calibrated first layer on your printer unless you are printing designs with very fine lines. The finish is great, I just need to clean up the prints a bit. If you're having trouble sticking filament, I'm pretty…

We have mixed feelings as we've made some great prints with this yarn but it took a few prints. Issues: 1) Adhesion to the build plate can be quite difficult. So difficult that we gave up and started using painters tape to make it happen as we couldn't get it to stick any other way (even with a raft). 2) He's a little more fragile than we're used to. too, causing it to click a few times in the extruder. Those few times there seemed to be no trouble anywhere else. 3) It seems to be prone to…