Review on 🖨️ Marble Filament Printing Printer by Eryone by Mark Lodge

I just received my first printer. . . Ender 3 Pro. Passed 1/2 roll Black PLA from Eryone and I really liked it. . no problems except a few mistakes i made which were user error. I just switched filaments to start using this marble PLA and it doesn't seem to print the same at all. Using the same setting that gave me near perfect results with black thread leaves a few lumps and feels more viscous. . . Adhesion doesn't seem as good as black, but it's not really an issue. We'll see how this one fares after a few more prints. So far I've had one print, Moai Head, well done in marble. . .Printed a bench that came out a little rough. . . Then I had a couple of bad impressions that produced a lot of spaghetti. I will let you know if I can get more points to fix the problems I was having. To update. . . After some trial and error I got it to print fine. It seems to print a little colder than black thread. Marble works better at a temperature of around 205°C with a bed temperature of 50-55°C. . . where black is happier at 210-212 with a bed of 60. Oddly marble seems to be harder too. . .My supports are really hard to remove from it and it leaves more rough edges. Look at the Raptor Claw in the picture.