Very easy to install. specified taillights. 3) Route the tow bar wiring harness under the bumper and up into the tail light housings. 4) Clean the area where you want to stick the controller/modulator box, remove the foil from the sticky pad and attach it. 5) wire brush. Insert and tighten the ground screw. (I also smeared on some dielectric grease to protect the connection) 6) Connect the taillight wires to the adapters 7) Reinstall the taillights as an assembly. Additional additional steps; 1) Find someone with a garage so you're not in the dirt. .2) Wrap the wire harness around the trailer wire harness and secure with tape before beginning installation. This protects the wiring from chafing/rubbing against the body. Very easy. The entire installation took less than 45 minutes and I was working on my back in the driveway. Very easy.
🧲 MUTUACTOR 2Pack 100lb Anti-Scratch Neodymium Rubber Coated Magnet: Versatile Magnetic Base for Off-Road Vehicle Lighting, LED Working/Signal Lights, Antenna, and More!
17 Review
🚗 LIMICAR Trailer Lights: Upgraded IP68 Halo Glow Kit for Trucks, Marine RVs, Boats, and Campers - Brake, Stop, Turn, and Tail Lights with License Plate LED - Includes 25ft Wiring Harness
16 Review
Nissan Brake Control Wiring Adapter: Tekonsha 3050-P - Enhanced for Seamless Integration
10 Review
Upgrade Your RV Connection With LATCH.IT RV 7 To 6 Trailer Wire Kit V2.0 – Weatherproof, Flexible And Easy To Install!
19 Review
Yokohama Ice Guard IG50 215/50 R17 99Q winter
36 Review
ORCISH 12V 13000-lb Load Capacity Electric Truck Winch Kit 🚚 with Synthetic Rope - Waterproof Off Road Winch for Jeep, Truck, SUV
35 Review
Nokian Tires Nordman RS2 SUV 225/60 R18 104R winter
32 Review
Nokian Tires Hakka Green 3 205/55 R16 94H summer
37 Review