Tow Ready 118496 T Connector Tacoma Review

This is a great kit to throw on a truck if you're a handyman and need to hook up a trailer quickly! I have a base 2014 I4 2 door Tacoma automatic and it worked great. Installation was a joke and only took 30 minutes! This is with the addition of a flex channel to clean up! The kit literally plugs right into your factory taillights and you're done! It might be a small thing, but the rubber stopper that covers the plug is secure and waterproof, great! I'm ready to lug this thing and soon you will

The instructions were correct for my car and not outdated as is so often the case. I installed this on my 2011 Toyota Tacoma in about half an hour, but it could have been done in half the time. The crockery looks consistently very high quality. After you have removed the two taillight mounting screws, you must pull firmly so that the two latches release the taillight. It's a bit confusing at first time, but nothing will break. It is designed for this type of work. I used some extra zip ties to…

Very easy to install. specified taillights. 3) Route the tow bar wiring harness under the bumper and up into the tail light housings. 4) Clean the area where you want to stick the controller/modulator box, remove the foil from the sticky pad and attach it. 5) wire brush. Insert and tighten the ground screw. (I also smeared on some dielectric grease to protect the connection) 6) Connect the taillight wires to the adapters 7) Reinstall the taillights as an assembly. Additional additional steps…