Review on Auburn Univ Brushed Chrome Hitch by Justin Fletcher
Nice looking thing, but be prepared to change the element to .
Nice part but be prepared to modify the part to fit the receiver cover. The factory hole is at the very end of the tongue that extends a few inches past the edge or hitch, no grommet near where it is required to seal on the receiver end. Requires a 5/8" drill bit and a drill bit to mark and move the hole to the correct location for a proper fit.
- Hitch Accessory
- Some complications
New products
Comments (0)
Top products in π Towing Products & Winches
SuperJump Trampoline with SuperJump 8ft (244 cm) net and ladder
29 Review
Cordiant Road Runner 195/65 R15 91H summer
24 Review
4WD ORCISH Recovery Traction Boards Tracks Tire Ladder For Sand Snow Mud - Set Of 2 (2Nd Gen Bag + Mounting Pins, Black)
39 Review
ORCISH 12V 13000-lb Load Capacity Electric Truck Winch Kit π with Synthetic Rope - Waterproof Off Road Winch for Jeep, Truck, SUV
35 Review
Another interesting products
Backpack XD DESIGN Bobby Hero Small black
20 Review
Zone Tech 5" X 5" Student Driver Magnet Sign - Caution Safety Warning, Please Be Patient (1)
18 Review
Executive computer chair Everprof Drift M, upholstery: imitation leather, color: brown
31 Review
Cute 3D Car Wind Up Key - Unique Decoration For Your Car'S Roof (Yellow)
15 Review