Review on 🌟 Premium Quality NovaMaker PETG Filament 1 for Exceptional 3D Printing Results by Jeremy Carpenter

I've had no luck with this thread. Yes it prints fine with minimal Cura profile changes from my PLA settings. Basically, I increased the printhead temp to 240 and the bed to 70 on my Maker Select V2. The parts look good but are very fragile. More brittle than the same part printed in PLA. The details just fall apart. From what I've read, this is usually due to the high moisture content of PETG filament, and this material was taken right out of the bag and placed in the printer. I've never had this problem, but all the pieces made from this thread are so brittle that they're unusable.