Review on Dream Lighting 4 by Adam Jenkins

If the bulbs you are replacing are held in place by "snap latches" or springs, be aware that using them as replacements will be frustrating. Why? Because it's not possible to put all 3 screws in the wood section where the old screw will be. The best you can do is position the 2 e screws. Now you can only see the edge of the existing hole and that part of the light falls down a bit creating a gap. Here's what you can do. Find a thin piece of hard plastic or coated cardboard. Slide the screw through the lamp base and secure it in the plastic. Set free. Install the other 2 screws in the usual way, then tighten the support screw until the base touches the ceiling. The inner lens is done.