Review on 🔧 TIMKEN-HA590242: Pre-Greased and Pre-Sealed, Engine Optimization for Better Searches by Kurt Bravo

I bought a pair of these to replace the factory originals on my 12 year old Jeep JKU. The bearing-hub assembly fits perfectly. The problem is that the wheel speed sensor cable is not as long as the factory one. In fact, he's probably 3 inches smaller. This is especially problematic if you have a lifted car. None of the moldings that surround the wire and snap into place at the factory are actually aligned. into a new hub until I figure it out. No!. The hole in the hub is slightly smaller than the factory hole and the stock wheel speed sensor will not fit! I only have a few hundred miles on bearings/hubs. and smooth. Workmanship looks fine. Buyers pay attention to the exact OEM replacement status.