Review on DIYHD Top Mount Black Barn Door Hardware Kit For 2 Bi-Folding Sliding Doors - Flat Track Rollers, No Doors Included - 37-3/8 by Jacob Richmond

We installed over wood panels so it wouldn’t smash the drywall. There are no words in the instructions- only diagrams. But it was easy enough to figure out what went where. Only issue was finding a 15mm drill bit for the stopper on the bottom of the doors.Basics instructions fyiBest with 3 people.Had to furr out the closet opening because our bifold doors were meant to go inside the opening instead of outside and thus smaller.Mark center of top sliding bar.Hold bar up and drill the 5 holes into wood stud. Attach the bar.Attach 4 plates at the tops of the sliding doors.Drill 2 holes for stoppers in bottom of doors at edges. Temporarily tape the stopper to bottom of doors.Put the doors on the track via the 4 rollers. Do not fasten. But be careful because they could fall off.Align doors as desired.Remove tape from stopper and mark where it hits the floor. Remove doors.Fasten stoppers to floor via 4 screws each.Put doors back up and tighten with Allen wrench.