Review on 🚗 Curt 56320 Ford Escape Custom 4-Pin Trailer Wiring Harness: A Perfect Fit for Your Vehicle by Micheal Looney

This actually fits my 2017 Escape, I should have taken more care and not listened to Revain's "it fits in your car" seat belt seat belts for 2013-2016 Escape. I cut it so I didn't have to make big holes to get the whole connector to the taillights and I didn't route the battery cable from the front but used the fuse tap and fuse panel in the trunk. , 5 meter wire against 20 run away under the car. The length of everything was enough, only part of the instructions I read was which side the only green wire goes from. I was wanting to redesign it to fit in the passenger side box next to the power supply but thought I might want to try my luck. I decided to leave the 4 pin end in the spare wheel well and route it through the floor/seal of the tailgate when connected to a trailer. Tested with a small light tester and with the trailer itself, everything works, doesn't work. not cause problems with car headlights. I very rarely tow a Terrible Fear folding trailer that I've upgraded to LED lights, but I'm pretty sure that would turn on the incandescent lights as well. Might try that if I get a semi and feel it can close the taillights drop the supplied lights on it. It's easy to install, it's installed in the car, for example, not outside, and the cables run outside, but whether I was alive really doesn't matter.