Review on 🖨️ Accurate Dimensional Printer Filament 1.75mm by Jon Bishop

Должен признаться, я влюбился в то, как аккуратно намотана нить на катушку, и я хотел сделать ее своей нитью для всех черных вещей, а также хотел, чтобы они было больше цветов to select. I was new to 3D printing and found that other coils looked so sloppy in comparison that they couldn't beat this material. Then I started encountering a lot of printing problems - and I always did when I ran this stuff through the printer. It took me a little time to make that connection. I think I was so amazed at how clean this filament looked on the spool and for the most part it seemed to work. If I were to print simple models with very few touches, this would work. But I've always encountered clogs and jams, and it's always been with this thread and not other brands I've used (like Overture). I tried a few things to improve the printing process, thinking there was something wrong with the machine, how to clean the hot end, etc. I'll admit that I've become an expert at clearing clogged hot ends ! I really wanted to like this filament but ended up throwing it away after finally concluding that the filament prints poorly under certain circumstances while I have had no problems with other brands under those circumstances.