Review on Revolutionize Your Printing Experience with Siraya Tech's Washable UV Curing Solution by Brent Borseth

After using Siraya Fast, I liked this resin for its claims of faster printing and easier cleaning. Unfortunately, I haven't had better print results than any other resin, and I haven't had any crashes, however when I tried cleaning with 50% alcohol (which should have been more than enough) it seemed like I could never get rid of all of the resin, it looks like the resin is only getting in the Water-alcohol moves mixture instead of dissolving like it should.I ended up removing 99% for a final rinse to remove any residue.Then since you don't have to dip in water to cure, the surface seemed to remain tacky and never being fully cured even after being in my UV chamber and under strong sun exposure.Finally, and most importantly to me, this seems done e part to react to water and/or moisture. I have n printed several prototypes with thin walls. D Despite their excellent printing, they began to warp and bow after a day or two as they dried in the warm air of the Arizona desert. Frustrated that my part was ruined, I did a test and put the part in a water bath for an hour and found that the cured plastic absorbed water fairly easily, turning my part into what I call "hard jelly". would. I suspect that if you only print thick, bulky parts and live somewhere with constant moderate humidity, this resin might work. I don't think this is a good idea if you want dimensionally stable parts with thin walls and very dry or humid air.