Review on 🔩 T-Track Hold Down Clamps - Woodworking Clamps - High Strength Aluminum Alloy 6063 - Fine Sandblast Anodized - Blue Color - 6-3/8 Inch Length, 1-1/4 Inch Width - 2 Pack by Jerry Delic

These are great for my new reload stand considering the different gear I use. Be very careful when using a router to cut grooves on a bench. The diagram shows a 3/4" width, so I bought a 3/4" plunge router and used a metal guide to guide it. Well, the slot that was cut measured exactly what the diagram called for, but wasn't wide enough for their T-slots. I couldn't even hit her with a rubber mallet. I had to widen the slot from 1/16 to 1/8 to get them in. I had no problems with the screws as some others have mentioned. I pre-drilled all the holes and didn't tighten them with a drill/screwdriver. Would use again as the price is right.