Review on VViViD Epoxy High Gloss Carbon Fiber Automotive Vinyl Wrap (Grey by Tim Rushing

I used this product to create a design on the back of one of my cars. The tailgate had a crack in the tailgate (common SUV year). The hint I found after making a few mistakes was this: 1) Clean the surface with alcohol or hand sanitizer gel and a clean white rag. Clean thoroughly and make sure that there are no fibers from the cleaning cloth on the surface to be coated. 2) Remove the protective plastic film from the carbon fiber part. 3) Be patient. Apply slowly and carefully as you will find that the surface of the product is applied quickly and adheres well. (Most people who complain that it's not sticky probably haven't cleaned it with alcohol! 4) CAREFULLY use a heater or low-temperature hair dryer to heat it while smoothing it down with a cloth . Heat and smooth, heat and smooth continuously until product forms around curves. A NOTICE. This product is quite thick so it will take "some time" to mold around the curves, but with patience you will develop your technique and it will work well. Enjoy!