Review on 🚗 Dorman 926-445 Front Passenger Side B Pillar Molding for Chrysler/Dodge Models - Black Finish by Bob Schultz

Installation is very simple, but here are some instructions and details to keep in mind: 1. Remove the screw (requires a hex sprocket) INSIDE the B-Pillar against the underside of the molding.2. Make sure all previous sticky pads have been removed from B.3. DO NOT (repeat, NOT) remove the adhesive backing from the new part until it is in place. This will make installing a new part in the field much more difficult. Align the two tuck-in tabs on the new part over the corresponding slots in the B-pillar panel.5. STRONGLY press the new part against the B-pillar by sliding it down so the tabs fit into the slots and the round pin at the bottom fits into the hole in the B-pillar.6. Reinstall the screw from step 1.7. Pull on the adhesive backings (they are intentionally longer to go beyond the bar you just installed).8. Tape the strip firmly against the B-pillar at the top and along the vertical side to secure it to the vehicle.9. Throw the plastic wrap and cardboard in the trash.