These boards have a 100 ohm current limiting resistor. Assuming a 1.2V, 20mA IR LED, a 190Ω resistor is required when 5V VCC and 105Ω at 3.3V VCC. This is why such a high failure rate is too much current for an LED at 5V. Solution: Either use 3.3V VCC or replace the 100 ohm resistor (marked 101 on the resistor) with a 200 ohm one -Resistance. I did the latter and the LED lived for 4 days while the original died after one day.
🌐 MCIGICM 2 Channel DC 5V Relay Module: Optocoupler Low Level Trigger Expansion Board for Arduino UNO R3, DSP, ARM, PIC, AVR, STM32, Raspberry Pi
11 Review
Vilros Raspberry Pi 4 4GB Complete Starter Kit - Black Fan-Cooled Aluminum Case for Heavy-Duty Performance
12 Review
REXQualis Comprehensive Starter Kit with Arduino MEGA 2560 & Detailed Tutorial for Arduino IDE Compatibility
11 Review
Gikfun Screw Shield Expansion Board: Enhance Arduino UNO R3 with the EK7007 Add-On
11 Review
🔧 Premium Repair Replacement Screws & Tools for MacBook Pro Retina 15"/13" - Complete Bottom Case Set
10 Review
uxcell 3.5" HDD Screw Black 200pcs for Computer PC Case - Flat Phillips Head - 6#-32 - Hard Drive Fasteners
10 Review
Glarks 660 Pieces Phillips Assortment Motherboard
10 Review
36-Pack Black Rubber PC CPU/Case Fan Screws/Rivets Set for Computer
11 Review