Review on 🔧 D14 55 Dovetail Whiteside Router Bits by Joe Garczynski

This milling cutter looked sketchy at first. I tried cutting through 4" cedar bolts to connect the sides and it sounded like it was stuck and it was tough. Well it was my stupid mistake because the bit came loose in the router (I had it in the router chart). I put on the bit holder and voila. It is sharp and cuts through both soft and hard wood like a hot knife through room temperature oil. Whiteside is one of the best cutting plotter manufacturers and it shows. It's definitely worth the money as the cuts are great, it's stayed sharp after a few projects and the dovetail grooves it makes are smooth. On some projects I had to run firewood both ways of my table, but I did it with no problem. Highly recommended!