Review on 🔌 Enhanced 7-80V Motor Controller Switch by RioRand by Joe Fulce

This RioRand motor speed controller is perfect for my Watersnake trolling motor with 24 lbs of thrust. I was able to remove the ribs in the white top half and attach the controller with a single nut and bolt to attach the device to the top inner half. The 11 1/2 inch cable to the control switch was then routed through the handle and attached to the front of the trolling motor by drilling a 5/16 inch hole in the end of the handle. I cut off the inside of the handle leaving about 4 inches, but the outside of the handle is left flat. The controller was easy to connect in the head by cutting the red and black positive and negative wires to the battery terminals. Simply attach them to the device as shown in the picture. I also cut 10 inches off the shaft for use inside and in the Hobie drive.