Review on 🔧 BAL 23222 Set of 2 "C" Jacks with Handle - 22": Sturdy and Reliable Lift for Easy Maintenance by Sean Young

Sturdy, well made, easy to install after I bought the hardware for it. The box was damaged in transit and I couldn't tell if the mounting screws were originally included. There are several models so measure carefully to ensure you have the correct width and rise height. They hang down a few inches (3 1/2?), so keep that in mind if you already have a gap problem. On my trailer, it takes about 15-20 turns to lower each jack. The only difficulty with installation is that movement of the joint at the intersection of the horizontal transom and post can change the distance to the inboard end of the transom if that makes sense. . So if you hold the compressed jack up and measure and drill the holes, then adjust the outer ends and rotate the jack down to support yourself during this part, then the hole on the inner end of the crossbar may not line up with the hole. You drilled into the trailer. Simply lower the jack and press everything against the trailer floor as you did when measuring and drilling and it will fit again. It took me a few minutes to figure out what was wrong.