I have a couple of basic moisture meters and another fully functional one. Switch on, chop wood, check. Move. Repetition. So I took some wood samples. I checked the humidity with other devices. They were within 1% of each other. I used this counter - the difference was almost 15%. every time So I tested it on the calibration sensors in the header. Wow, not even close - 18% reading 22%, 26% reading 29%. The manual says the device can be calibrated in CAL mode and tells you how to get into CAL mode. But that's all. There are no instructions for the actual calibration. I have a meter with a set screw - no, not here. The other uses the control panel. I tried. I get a "bAd" error message or I turn off the device. So pens are useless to me. The thermometer deviates by 8 degrees. The relative humidity has been reduced by at least 40%. I am currently in a room with a relative humidity of 18% and a temperature of 78 degrees Fahrenheit. Close. So if there's no way to calibrate it by the user, it's a paperweight.
Thermometer B.Well WF-4000 white
57 Review
VIVREAL 4 In 1 Stud Finder Wall Scanner With LCD Display - Center Finding Beam Finder And Sound Warning For Wood, AC Wire, And Metal Studs (Black/Silver)
24 Review
Room temperature and humidity sensor Aqara Temperature and Humidity Sensor white
25 Review
ICQUANZX LCR-T7 Transistor Tester: Advanced TFT Diode Triode Capacitance LCR ESR Meter
14 Review
Kapro 307-08-TMS Try And Mitre Layout And Marking Square With Stainless Steel Blade, 8-Inch Length
18 Review
๐ CAMWAY 6 Inch Digital Caliper with LCD Display, Electronic Vernier Caliper, 150mm Stainless Steel Feeler Gauge, Plastic Digital Caliper Set for Zero Setting Inside/Outside Diameter, Depth, and Step Measurement Tool
3 Review
TV bracket Kromax DIX-18 black
52 Review
๐ฒ Johnson RAS-1B Johnny Square: Professional Aluminum Rafter Square, 7'', Silver - Top Quality with 1 Square
8 Review