. I used this to straddle the 3/4" heater hoses from the heater in the back of the van. There are two latches under the hood. This allows you to quickly find a solution if there is a leak in the rear of the van while maintaining roadworthiness. The fit is not good for the 3/4 inch rubber heater hose. The valve falls right out of the house without the clamp. But with a clamp it tightens enough. I'm assuming it's for 3/4" PEX or some other 3/4 standard. Not rubber tubing. Also, the ball valve isn't what I would call full bore. I forgot the size, but it was noticeably smaller as ID fittings. Maybe 1/2" or 5/8". That's not a problem for me but should be considered if one has high flow requirements. Despite these minor disappointments I give 5 stars as it's well made and probably works great in the applications it's really intended for.
Joywayus 5/8" ID Hose Barb Hex Union Brass Fitting Water/Fuel/Air With 10 Stainless Steel Clamps (Pack Of 5)
13 Review
High-Quality QiiMii Stainless Steel Sanitary Clamp With Silicone Gasket - 2 Inch, Single Pin Tri Clover Design
16 Review
DIGITEN DC 12V 1/4" Inlet Feed Water Solenoid Valve Quick Connect N/C Normally Closed No Water Pressure
14 Review
Upgrade Your Draft Beer Kegerator With The TerraBloom CO2 Keg Pressure Regulator - Dual Gauge Heavy Duty Unit With Safety Features
16 Review