Review on 🔧 Impact Rated IRWIN Bolt Extractor Set: The Ultimate Solution for Lug Nut Removal (1859146) by Non Dollarz

I had to loosen the rear seat belt bolt on my car (torx bolt) which was not well rounded (see photos). I've tried several supposedly 'tried and tested' methods (drilling a hole in it and then using an extractor, vampires, etc.) but all have failed miserably. The more I looked at the bolt's head, the more I realized I needed something that could grab it from the outside without further damaging it. After studying the specific design of the Irwin bolt extractor, I had a feeling this would be the only one that would do the job. After selecting the 22mm extractor, after a few seconds the shutter began to move almost effortlessly! I was amazed that it didn't take much effort to get the bolt out at all as the extractor did all the hard work. All I can say is that I am now confident and will always rely on Irwin pullers to get the job done when it comes to removing badly rounded bolts/screws from now on. Other methods and puller kits may work for you (depending on what screw/bolt you're trying to remove, its size, location, and condition), but this is by far the easiest, safest, and quickest way to get those stubborn screws out . and your hair.