Review on 🔌 NinjaTek 3DNF08117505 NinjaFlex Filament TPE 5Kg: Flexible and Durable 3D Printing Material by Will Jenkins

The boys at ninjaflex You should invest in a vacuum sealer. It's not just about moisture. It lasts it tight.It's frustrating what to waste.This stuff is worth it and you get a spool of what can become a constant bane of bad prints due to tangling.It's not as bouncy as PLA but when you get a brand new product open up and see a few layers that are loose and need to be untangled This makes your processes look like hot junk under the coil and sticking out the side into the coil and subsequent layers tightened on top I'm not sure I "I've never seen this before. A piece of tape to keep this from happening on the top wrap. The drive end on the side of the spool? That's all you need. If it helps you I have every right to post it immediately as a transport sch." to return. Are you sure you don't want that? It hurts your business. I know that these reviews need to be based on the product itself and not on the packaging or things that are not under the merchandise's control. Since this is a direct manufacturer error, I consider this to be absolutely relevant. The picture shows the end of the first layer sticking out over the edge. Just crazy.