There is no wiring diagram in the box. . If you're migrating from a mirror that doesn't currently have turn signals, running lights, or a defrost circuit, you'll need to run wires for each and a ground wire. A rather lengthy work awaits you. Use your current 3 wire connector to control the movement of the mirror, then run any additional wires into the new mirror wiring harness. The turn signal bulb (top) is brighter than the low beam bulb (bottom) as it should be. I hope my color codes help you a lot. For this money are good. Take extra care to slowly tighten and rock to a seated position when installing. When tightening, do not rely on the mounting nuts to tighten the mirror flush! The mounting studs will pop right out of your new mirror! Install by hand, not with the studs. It's better to have an assistant.
4WD ORCISH Recovery Traction Boards Tracks Tire Ladder For Sand Snow Mud - Set Of 2 (2Nd Gen Bag + Mounting Pins, Black)
39 Review
Get Ultimate Towing Stability With CURT TruTrack Weight Distribution Hitch & Sway Control - Up To 10K Capacity, 2-Inch Shank & 2-5/16-Inch Ball - In Sleek Black Design
30 Review
SuperJump Trampoline with SuperJump 8ft (244 cm) net and ladder
29 Review
Cordiant Road Runner 195/65 R15 91H summer
24 Review
Nokian Tires Nordman SX3 185/60 R15 88T summer
30 Review
Stroller Happy Baby Ultima V2 X4, beige, chassis color: black
23 Review
Cute 3D Car Wind Up Key - Unique Decoration For Your Car'S Roof (Yellow)
15 Review
Zone Tech 5" X 5" Student Driver Magnet Sign - Caution Safety Warning, Please Be Patient (1)
18 Review