Header banner
Revain logoHome Page
Marfel Fekete photo
1 Level
774 Review
82 Karma

Review on πŸŒ€ Dust-Collecting Wheel Guard for 4.5 Inch by Marfel Fekete

Revainrating 4 out of 5

does not fit Makita 9237CX2

I had to wrap a few turns of tape to close the gap to keep it on the sander because after tightening the shoulder bolt there was a decent gap and the guard didn't pinch the sander on the neck. After that it worked fine for dry polishing concrete, but the vacuum hose connector had to be larger to help with the suction CFM because it got stuck in my vacuum. The guard didn't work well when I had to set up a grinding wheel to level the raised spot, it shot small bits of concrete through the bristles and throughout the room. So over the summer I bought a 7 inch Makita burnisher, a Mikita dust cover and a 10ft Mikita hose set and I still had to use tape to attach the guard to the burnisher and tape to the hose connectors , since it did not fit any friend. either an expensive rustic facility :(.

Pros
  • Confident
Cons
  • Expensive