Check Engine Light - Ford Fusion 2.0 2016 - Code P144c. This part solved the problem. DO NOT replace the entire wiring harness. Read the comments and watch the repair video - Harness clamps are not possible. Use a hair dryer to remove the tubing from the part. 1) Leave the old valve in place/snap in place and use a hair dryer (carefully) to heat the heat shrink tubing. Too much heat will melt the tube and turn it into a puddle, so heat the connection between the tube and the valve while using enough force to pull it out. (It's a lot easier when it's still attached.) 2) If the hose is removed, disconnect the valve and replace it. Wrap the tubing in new shrink wrap and secure with a heat gun. It's a 30 minute fix as long as you don't mess around with other clamps.
Gasoline generator Huter DY9500L, (8000 W)
34 Review
TOTALFLOW 646 Mini Muffler 409SS 4.5" Round Width 4" Body 6" Overall Length Inner Inlet-3.5" Outer Diameter Outlet
39 Review
LEDAUT T3 Titanium Turbo Blanket Thermal Cover With Fastener Springs For Enhanced Turbocharger Heat Shielding
23 Review
50' Titanium Exhaust Heat Wrap Roll For Motorcycle Fiberglass Heat Shield Tape With Stainless Ties By LEDAUT 2
28 Review
2007-2017 Jeep Wrangler JKU 4 Door Sunshade Mesh Top Cover - Durable UV Protection With US Flag Design - Voodonala
31 Review
Off-Road Fender Flares For Jeep Wrangler 2007-2018 JK & JKU Unlimited - Heavy Duty Flat Textured Steel Mud Guards In Black (Set Of 4) By Hikotor For Front And Rear Replacement (2 Or 4 Door Options)
47 Review
Replace Car Bumper Clips: GOOACC 100Pcs For Nissan, Mazda And Infiniti, Including Fastener Remover
33 Review
Upgrade Your Mazda MX-5 Miata With CravenSpeed'S USA-Made Door Bushings
39 Review