Review on 🍺 BEERGON 1-TAP Beer Tower Cooler Insulator - Dark Grey Neoprene Cover (4 mm Thick) - Single-Tap Tower Protection with Extra-Wide (1.2”) Hook-&-Loop Fastener - Fits 3” Wide 12.5” High Beer Towers by Corey Milton

I ordered this for my Dual Tap EdgeStar Kegerator. Lately I've noticed I'm getting very sudsy downpours even though I have a built in cooling tower in my kegerator. After thawing my kegerator, switching to Perlick non-stick mixers and setting them up properly, I was still getting my first few frothy pours. Since this problem started with the onset of warmer summer weather, I decided the built in tower cooler needed help from the tower isolator. -- There is an inch of exposed turret at the bottom. So be sure to measure before you buy. Installing the isolator takes a few seconds and you don't have to remove the faucet handles or faucets. However, I would have preferred the velcro design on the back of the tower rather than the front to make it a bit more aesthetic. After installing it, I waited a few hours before pouring the beer and noticed less foam the first time I poured. While the insulator is a little ugly, it helps reduce foam build-up, which is the most important thing for me. I suspect an insulator that fits my tower properly would work a little better.