I am using Arduino 1.8.13 to program ESP32 boards. Work. I then tried the new camera board on my old TTL programmer. That didn't work either - no reaction from the camera. To make sure my TTL setting works well I tested one of the other camera boards and it worked fine. In short, not a single programmer sees the new camera board. So my conclusion is that the new camera is dead. I also tried using the serial monitor via the programming board on both the new camera board and my old camera board - all I got was the board not being available. So my conclusion is that the programming board is also bad. I also tried two different USB ports on my computer (USB 2 and USB 3.1). My old TTL programmer worked fine with a good camera board on any type of USB port. I cannot recommend this device.
π MCIGICM 2 Channel DC 5V Relay Module: Optocoupler Low Level Trigger Expansion Board for Arduino UNO R3, DSP, ARM, PIC, AVR, STM32, Raspberry Pi
11 Review
π Ultimate BBC Micro bit Sensor Starter Kit: Keyestudio 37-in-1 Box with Tutorial, Compatible with V1.5 & V2, Gift for Kids and Adults (Microbit Board Not Included)
11 Review
Gikfun Screw Shield Expansion Board: Enhance Arduino UNO R3 with the EK7007 Add-On
11 Review
Vilros Raspberry Pi 4 4GB Complete Starter Kit - Black Fan-Cooled Aluminum Case for Heavy-Duty Performance
12 Review
Comprehensive 500pcs Laptop Screw Kit Set for π© IBM HP Dell Lenovo Samsung Sony Toshiba Gateway Acer
12 Review
π§ Premium Repair Replacement Screws & Tools for MacBook Pro Retina 15"/13" - Complete Bottom Case Set
10 Review
uxcell 3.5" HDD Screw Black 200pcs for Computer PC Case - Flat Phillips Head - 6#-32 - Hard Drive Fasteners
10 Review
Glarks 660 Pieces Phillips Assortment Motherboard
10 Review