Review on Shimmering Crystal Printer Filament with Speckles by Jesus Olsen

If you want to deal with your heat shield pads and clogged nozzles, then this is the filament for you. Clogging any print with this filament for about 20 minutes is almost useless. If you somehow force it to print, the filament will look fine after printing, but most likely partial or full clogging will occur, resulting in poor layer adhesion and failed prints, wasting filament and time. Prusa thread as they give the same color which I have used with no problems. All in all this filament is useless unless you really want to change nozzles etc in your printer. I wouldn't recommend this at all at the moment unless they improve the filament which I don't know about because I won't be buying again.