Header banner
Revain logoHome Page
Micha Dziubiski ᠌ photo
1 Level
336 Review
0 Karma

Review on BERKUT Specialist JSL-12000 black by Micha Dziubiski ᠌

Revainrating 1 out of 5

Terrible quality, a waste of money.

I am writing this review so that people would notice that this is a START-UP, but not a charger for car batteries. Answer from Berkut service manager: "The battery is not charging. Only helps to start the engine in case of a discharged battery. Well, a power bank for charging gadgets . The battery must be charged at room temperature using special chargers. Check out the BCA-4 and BCA-10 chargers"

Pros
  • A successful attempt is described in the shortcomings as case 1, I do not consider it an advantage, therefore I did not add it to the merits. Charges devices, has not yet experimented with how long the laptop will live with ROM, but charges.
Cons
  • Purchase day: I bought a device with a start-charger in the section of devices for car batteries. Total came device Launcher for the car. Charger for gadgets. Decided to leave, tried twice. Case 1: the battery, after it did not start, brought it home, until I bought a ROM, it stood warm for a couple of days, they brought the ROM, decided to take it out and install it in the car and check the ROM before charging, the voltage was at least 11.80V. I installed and connected it to the car, connected the firmware, tried to start it, the car started up with a half kick, and the battery showed 12.50V before charging. It's strange, but I thought, it seems to work, I'll leave it. Case 2: Frost -30, windy, Skoda Octavia Tour 1.6 ran out of power. Tried to start it a couple of times, but nothing. I decided to take the ROM out of the house and start the car with it. ROM charge 75% (3 out of 4 divisions), connected correctly in polarity, the indicator is green, tried according to the instructions (3-5 seconds) - it didn’t start, waited a minute, tried again, waited, tried a third time. UNSUCCESSFULLY. DISAPPOINTMENT. After trying, the charge at the ROM is 1 division. There is no adapter included in the kit to use the ROM as a cigarette lighter socket.