Review on RV Designer H601 Screw Covers by Chris Lapan

In short I have an old bathroom and a bathtub all around. This is a 4 piece bathtub. We use a 3 piece bathroom set. The middle end molding never wanted to stay as tight as I would have liked. Over time, the coin will break and become detached. I've always used screws of any kind to hold the bezel in place, but they were ugly. I bought new stainless steel pan head screws because they don't rust and so do these caps. They worked great! Before inserting the screw into the back, I put a strip of silicone on the back of the back where the hole that runs next to the panel is, then inserted the screw and screwed it in. I did this just to give myself a little better waterproofing and then put the lid/cap on the back, very light weight and nice looking. I had no problem with one of the caps falling off. Note that I put in a few screws that weren't there before, so I pre-drilled the holes and then used the same process. You don't have to use sealant on the back of the caps, but I only did this to improve the water tightness around the screw. I love them and will definitely buy them again if I need them for other projects.