Review on 🌡️ Pymeter Dual Probe Plug in Temperature Controller Heat Mat Thermostat: Ideal Solution for Terrariums, Aquariums, Brewing, Seedling Germination, and Greenhouses by Leon Thompkins

This is perfect for my QIDI S-Box 3D printer which has plenty of space behind the resin tank. I mean I bought a 110v mini heater and ran a wire from the cooking chamber to the temperature controller. I then attached it to the back wall with a magnet. I also pushed the thermostat probe into the chamber. I connected a personal heater ) to this extension and set the appropriate temperature. That works great. I typically use Siraya Tech resins which require a heated chamber. It takes about 20-25 minutes for the camera to reach the set temperature of 86F (or 30C) and I'm good to go. Holds the temperature very well. I couldn't do it without this temperature controller. And I can run 2 separate heating settings for each of my 2 Qidi S-Box printers as each socket has its own separate sensor and settings!