The best way to attach these feet so they don't fall off the bottom of your Macbook is to use some heat. I removed the bottom panel with the included 5 point screwdriver. Inside this plate you will notice that 4 feet are covered with some kind of thin black material on the inside. Either clean it or poke a small hole in it to knock out the old legs. All replacement feet have a short "tube" at the back that should protrude through small holes in the bottom panel. The trick is this: after attaching the new foot pad, heat this little "tube" with a hair dryer and press down a bit with something hard (I used the back of a screwdriver handle). like a rivet, and the leg is now physically attached to the floor panel just as it was at the factory.
M.2 Screw Kit: Easy Mounting for NVMe SSDs on ASUS Motherboards
19 Review
uxcell 3.5" HDD Screw Black 200pcs for Computer PC Case - Flat Phillips Head - 6#-32 - Hard Drive Fasteners
10 Review
MacBook Retina 13-inch (A1425, A1502) and π© 15-inch (A1398) Bottom Case Screw Set with Pentalobe Screwdriver
11 Review
Comprehensive 500pcs Laptop Screw Kit Set for π© IBM HP Dell Lenovo Samsung Sony Toshiba Gateway Acer
12 Review
π UCTRONICS GPIO Breakout Kit for Raspberry Pi Pico - Assembled Pi T-Type Breakout + 830 Tie Points Solderless Breadboard + 40 Pin Male-Female-Male Rainbow Ribbon Cable + 65pcs Premium Jump Wires
10 Review
DSD TECH 2 PCS IIC OLED Display 0.91 Inch: Perfect Arduino ARM Accessory
9 Review
Complete Kuman Raspberry Pi 4B 3B+ Kit: Breadboard, Expansion Board, Jumper Cables, Ribbon Cable, Resistance Pack
9 Review
Enhance Your Development Projects with the NVIDIA Jetson Nano Developer Kit (945-13450-0000-100)
12 Review