Review on UCTRONICS Programmable Enclosure Automobile Industrial by Sean Garrison

I use this for a very specific type of LED lighting to dim an area and then when the motion sensor is triggered the lights come on VERY slow in all modes. It was possible to set a delay for the lightening and then set it for a time long enough to slowly lighten for two minutes. I built the slow lightning chain separately. Then stay bright for 3 minutes at all times during the cycle. When motion starts again, the sequence timer will restart (leave bright light on) until motion is detected for the timer time, then turn off to slowly dim. This allows the prey to feed at night and not be startled by the lights. And saves energy as the system is charged daily by solar energy. The only reason for 4 and not 5 stars is to determine the decimal settings of the timer. SO.///.Start setup/program mode, switch to the "NX" LED. The rightmost digit sets the multiplier for the "T1" timer 1 = 1x9999 seconds 0 which was factory set allows the timer to run for only 60 seconds, MAXIMUM 9 which IIRC uses to increase the time to 27 hours can!?!? SECOND DIGIT RIGHT Time Multiplier "T2"