I'll be brief. I was interested in the case of One, also by Argon. However, they seem to be sold out almost everywhere. I have that too with her fan hat. Everything came together very easily. There are 4 screws (6 if you want to install a fan). Looks stylish and looks massive. I like it. My problem is the lack of a vent at the top or sides. There are some neat little slits on the lower plastic part that allow for some ventilation. However, this is not enough. I overclocked the CPU to 2147MHz and did a stress test on my Pi 4. After 20 minutes, the temperature finally peaked at around 74 degrees. Not bad, I shouldn't expect gas. If I take off the top, the temperature drops by 12 degrees. So without a top, my average temperature was around 62 degrees Celsius. What is it for? That's a good deal. Much better than just using a heatsink. However, this is no better than using a fan gasket. If they added vents or cutouts at the top the case would be able to breathe better and I would give it a 5/5.
π MCIGICM 2 Channel DC 5V Relay Module: Optocoupler Low Level Trigger Expansion Board for Arduino UNO R3, DSP, ARM, PIC, AVR, STM32, Raspberry Pi
11 Review
REXQualis Comprehensive Starter Kit with Arduino MEGA 2560 & Detailed Tutorial for Arduino IDE Compatibility
11 Review
π Ultimate BBC Micro bit Sensor Starter Kit: Keyestudio 37-in-1 Box with Tutorial, Compatible with V1.5 & V2, Gift for Kids and Adults (Microbit Board Not Included)
11 Review
LAFVIN Super Starter Kit for Arduino R3 Mega2560 Mega328 Nano with Detailed Tutorial - Compatible with Arduino IDE
11 Review
π₯οΈ Helifouner 450-Piece Computer Standoffs Spacer Screws Kit: Ideal for Hard Drive, Motherboard, Fan, Power Graphics & Computer Cases
10 Review
Comprehensive 500pcs Laptop Screw Kit Set for π© IBM HP Dell Lenovo Samsung Sony Toshiba Gateway Acer
12 Review
Glarks 660 Pieces Phillips Assortment Motherboard
10 Review
M.2 Screw Kit: Easy Mounting for NVMe SSDs on ASUS Motherboards
19 Review