Review on 👍 Efficient Filament Cleaning with CooBeen Dimensional Fiber Infill: Improve Print Results! by Kyle Hood

So I'm still new to the 3D printing community. Although I've been a CNC programmer and operator for over 15 years and have read a lot about additive manufacturing, it goes without saying that I'm a quick learner. Point for most of my PLA filaments. I had some stretch and the stack was weak. I made some adjustments and now I have almost no bad spots or stretches. Strong impressions. I even increased the feedrate to 100mm/s with an acceleration of 1000 (I changed Cura's default max to 5000 under admin). I use Cura 4.11 for slicing. Print speed 75mm/s210⁰C and 45⁰ to 55⁰Retract 0.5 (3.5 non-direct drive) Comb - ALL turning on the roll is nice too. Glass table with glue Elmer's Washable School