Review on Enhance Accuracy with the ProSensor T13 Professional Stud Finder: 13-Sensors for Unparalleled Precision by Rashid Summers

Love this thing. I have had 2 Cubic Zirconia Spike Finder in the past. I still have them and they work. However, they are slow. Press the button, scan, repeat 3-4 times to check the side or edge of the stud. This tool is a whole different experience. The pin is marked with LEDs. Usually 2-3 LEDs signal a hairpin bend. Hover the tool over the stud and the LEDs will light up instantly. Enormous time savings. I bought this tool hoping it would save my hand when working on my head. And so it was. I went back and changed my other spike seeker's markers, which were quite painful and slow. I love this tool! My walls and ceiling were regular 1/2" thick drywall on 1 1/2" to 2" wide studs and rafters. I haven't tested it on denser walls than drywall (no lathe, plaster or concrete). But for modern construction or remodeled walls it's amazing I've gotten weird readings here at times but overall it's been as good or better than my zircon at stud tracking It's a lot easier Worth the money if it lasts I bought this because I wanted to fit an attic ladder in a new interior room. I've used it for wall mounting ever since. I think there's another model of this sensor that can take current. I have the T13 ProSensor version. Shows no wires, As far as I can tell I haven't read the instructions I definitely recommend it.