Review on Cllena Dual USB Socket Charger with LED Voltmeter and 12V Power Outlet: Four Functions Panel for Car Marine Boat RV Truck Camper (Blue) by Ricky Mayo

I was planning on replacing the 12 volt plug on my RZR with something I would actually use. Simply pull on the dashboard (bonnet open, 2 Torx T40 screws under the hood, dashboard fastened with clips to the rear). Pulled 2 wires from the factory cigarette socket and then pushed this factory socket out of the dash. First problem; The pin/outlet of the + or - cable of the new device is not the same size as the factory one. The factory has a small tab, a normal tab. The new block are both normal size so the wiring will not fit. There are 2 options here: cut the factory wire and rewire it, or cut this new block eyelet to fit. I've decided to shorten the 'New Units' tab. The factory did a good job with the wiring here, so I didn't want to stop their work. Second problem; The hole left over from the factory 12v socket is too small to fit this plug. Maybe I could force it, but instead I used a drum drill bit on a dremel and lightly scraped the hole in the dash to fit it. All in all, a 5 minute job turned into 15 minutes searching for tools and beats.