Review on 🔥 Ultimate Carbon Premium 3D Printer Filament: Unmatched Performance and Strength by Saul Rivera

This is the worst PLA you can buy, it clogs the nozzles. For me it clogged by half for a 36 hour print. The strings are very bad, difficult to get the flow through the jets in the beginning. Using the 0.4mm diameter tip, the bed temperature is 55 degrees Celsius and the nozzle tip is 210 degrees, everything works fine. This minimizes your rope and improves your grip on the bed. BUT EXPECT IT TO COME INTO YOUR PRINT ONE TIME. If you are looking for carbon fiber for strength and PLA for lightness. CHECK OUT OTHER PLACES. I found it no stronger than the PLA regulator. Everything is so bad that I started to think there was something wrong with my printer. After going through the reel I replaced it with a new PLA regulator. My car starts fine