🔥 Ultimate Carbon Premium 3D Printer Filament: Unmatched Performance and Strength Review

This is the worst PLA you can buy, it clogs the nozzles. For me it clogged by half for a 36 hour print. The strings are very bad, difficult to get the flow through the jets in the beginning. Using the 0.4mm diameter tip, the bed temperature is 55 degrees Celsius and the nozzle tip is 210 degrees, everything works fine. This minimizes your rope and improves your grip on the bed. BUT EXPECT IT TO COME INTO YOUR PRINT ONE TIME. If you are looking for carbon fiber for strength and PLA for…

Prints come out with no signs of warping. TLDR: Don't use PVA and heated, it sticks too well. The uncoated heating bed works great for me. For almost all filament I print I use a pva/water coated adhesive coating on heated borosilicate glass on my Ender 3 Pro with an E3D v6 hotend and a 0.6mm nozzle. When I was doing this with a big push I had to spend a lot of time trying to get him off the bed without damaging him. I rate this 5 stars because when I used an uncoated plate heated to over 60°C…

I get through a lot of sun. This is my pick for PETG and I order it in packs of 3 rolls from Amazon. I also order their wood thread in packs of 10 spools from the Sunlu website. I go through many Sunlu and I like them. So when I was looking for a matte black color for my CR10V2's new duo box, sunlu was the easy choice. One of the reasons I run through their PETG so often is that they usually end up dry. Not always, but more often than any other brand I've tried, even double the price. Sometimes