Review on KODAK Filament Dimensional Accuracy Consumables by Vedprakash Trilltight

The first layers off the roll were fine at the time. The layers are hidden under the layers, causing the printer to pull and break the filament. The coil winding is terrible. The chimp could have packed it better. How to wind a coil where layers are underneath other layers? To get any print at all you should try to pull the foot out and then roll it back as you print so it doesn't mess up your print. Adhesion to the printing platform is also poor. I run almost all of my filament at the same hot end and layer temperature, and this one of my many spools of filament won't stick unless I heat the bed much more than usual. Some areas stick, but the corners stretch and warp too easily. You also pay more for this as it is not a 1kg roll. I would avoid it if I were you. There are many more options with better price and quality.