Review on Proto Pasta Matte Fiber Black 1.75mm Filament by Sammie Rodriguez

I am making some car parts with this filament on a CR10S Pro v2 and after tweaking the settings a bit I got it pretty good. The handling of this thread is top notch! It's almost impossible to see the layer lines unless you use a magnifying glass. It also feels silky smooth! I love it! The main problem I have is sticking to the bed. My printing notes are below: UPDATE 10/2/21: If you are having trouble with the table sticking, try leaving it warm for the duration of your print job. It really helps a lot! For those finding it difficult to print with, I found the following to work on the CR10S Pro v2: I print at 210 with an initial layer at 212. Build plate temp at 55 with an initial layer at 58. Initial layer linewidth at 160 %. layer height 0.17. The initial height of the layer is 0.11. Line width 0.4. I use margins for larger prints with small footprints. Set the fan speed to normal at 22 (to allow the first 21 layers to cool more slowly to avoid warping. My room temperature is around 80F and my house is very dry.