Header banner
Revain logoHome Page
Moises Dzihic photo
1 Level
1271 Review
79 Karma

Review on πŸ”§ Greenlee 645 1 1 Stainless Change Cutter by Moises Dzihic

Revainrating 5 out of 5

Great tailors!

I used step drills to cut holes in stainless steel for a small fabrication shop. These things caused him to lose his job. Step drills, whether cheap or high-quality, are short-lived when machining stainless steel. The one-size-fits-all Greenlee cutter, which I use most often, shows no signs of dulling after about 50 cuts. With these torches, once the cut is complete, the torch rests against the edge on the side. Allow the cutter to stop in this position before removing it from the hole. Otherwise, the cut-out ejector spring will inevitably get caught on the side of the recess, peel off and fly to no one knows where.

Pros
  • This is amazing
Cons
  • Some mistakes