Review on Nilight Aluminum Rocker Pre Wired Warranty by Meechie Camlin

Overall I am very satisfied with the product, it conforms to the description and comes with what can be seen in the photos. Here are the details: Pros: The frame is aluminum, not plastic. Switches can be removed and rearranged or replaced after you have them. where the screws are clamped (not in my case) no choice which switches you get (it doesn't really matter in my case, 2 out of 3 were what I wanted, I already had the third one anyway) Pre-assembled, but the wire is very short when So you have power and ground very close, you need to connect them with wires that you need to run a distance. Parts, the switches themselves are 5 pins, 1 pin goes to a relay or device depending on the current draw of your device and how you connect it, 2 pins are for grounding the LEDs in the switch to illuminate the image when it is on and the word if powered by the light circuit or otherwise, the other 2 pins are hot say one of which should be switched to the light device relay, the other back to the word if powered by the light circuit or on powered in any other way. I don't like having all the power connections on the same circuit as that drains my battery 24 hours a day 7 days a week as I don't turn on the master breaker as its in my truck if you have a master breaker thrown away then this wiring is for you. Having everything negative might be fine, but since I have grounded wiring harnesses, my setup doesn't require it. I'd love to see the ability to choose the exact switches you get, again I had what I needed so it didn't really matter to me. See in the picture, I used angle brackets I got from the store at home and hung under my dash a little if I can reach them but it works for me. In general I like it more than what I would do in plastic.