Review on 🔧 Lisle 33960 9mm Brake Caliper Hex Tool Set by Rudy Barron

I don't think you even get what you pay for. The cutout for the square disc doesn't match the outer circumference, so the whole thing wobbles a bit. The actual bit is also not pressed in parallel. It is even better if it is not offset in the opposite direction so that the two errors add up and the whole thing is a few mm off-axis. Plenty of it over the ratchet handle and it can cause the end of the handle to move back and forth many inches so tight spaces can be fun. Good thing I have a cheap Craftsman driver with about the same backlash. As you can see from my photo they didn't even clean up some of the trim. That's a pretty low level even for Chinese production. If it survives 4 pins I will have to let you know as I forget to update this or I will definitely change my rating.