Review on ⚡️ Enhanced Performance and Reliability: Standard Motor Products RY-640 Relay by Josh Ulrich

Got this relay for my 2007 Nissan Altima. My fan wasn't running with my heat or air so I did a little research and found out it was the relay. Useful advice for those who change it; It is installed behind the fuse box and on the far left. Remove the fuse cover and you will see a large screw holding the knee plate. Remove this screw and the plate will lower slightly. Then to remove the fuse panel there are three hex head screws (I believe they are 8 millimeters), one on top and two on the bottom. Remove them to access the leftmost blue relay. Once you have access to it, it will be a bit difficult to remove due to the limited space. I used Visegrip pliers to secure it and pull straight up. It worked like a charm. Remember to look at the relay when removing it so you can replace it the same way you removed it. I think the two brass pins are going back but check to make sure. Start the car and turn on the fan to make sure the relay is set correctly. I'm pretty sure I saved a few hundred bucks by making it myself. . Good luck and be patient with it.